Stieber ASNU 12 Sprag Clutch Bearing 12mm I.D., 35mm O.D., 13mm Race Width

Denna bild representerar endast produktgruppen

Se alla Sprag Clutch Bearings
Mängdrabatt möjlig

Antal (1 enhet)*

1 955,30 kr

(exkl. moms)

2 444,12 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • 21 enhet(er) är redo att levereras
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
1 - 41 955,30 kr
5 +1 876,90 kr

*vägledande pris

RS-artikelnummer:
146-5269
Tillv. art.nr:
ASNU 12
Tillverkare / varumärke:
Stieber
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Stieber

Inside Diameter

12mm

Outside Diameter

35mm

Torque

12Nm

Race Width

13mm

Series

63

Over-running Speed

3300 (Inner) rpm, 50000 (Outer) rpm

Keyway

Inner and Outer Race

Drag Torque

1.6Ncm

RoHS-status: Undantagen

Type ASNU is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation. A typical arrangement is to install this type alongside a bearing within the same location tolerances. The inner race is keyed to the shaft. The outer race has positive n6 tolerance, to give a press fit in a H7 housing. Additional side notches in the outer race provide for positive torque transmission. If the housing is to K6 tolerance, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly. This design can accept an axial misalignment of inner and outer race of ± S/2.

relaterade länkar