Adafruit Controller Board for DRV2605L for Haptic Motor

This tiny little board is designed for controlling haptic motors. Rather than just turning the motor on and off, this controller has a range of vibration effects stored in the chips memory. For example, the vibration level going up and down, 'click' effects, different buzzer levels or the vibration pattern following a musical/audio input.

The controller chip is the TI DRV2605 (RS 914-2942) and can be used with both Linear Resonance Actuator (LRA) and Eccentric Rotating Mass (ERM) type motors. The chip is controlled over I2C and compatible with both 3 V and 5 V power/logic.

Arduino code is available from Adafruit.com and porting it to other I2C-capable processor is relatively straight forward.

Board dimensions: 25.8 x 17.8 x 4.6 mm
1.0 g

Motor Controllers & Drivers