Pico Technology Oscilloscope Probe, Active, Differential Type, 200MHz, 1:10

Se alla Oscilloscope Probes
Inte tillgänglig
RS kommer inte längre att lagerföra denna produkt.
RS-artikelnummer:
898-6753
Tillv. art.nr:
TA045
Tillverkare / varumärke:
Pico Technology
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Pico Technology

Probe Type

Active, Differential

Attenuation

1:10

Bandwidth

200MHz

Maximum Common Mode Input Voltage

60V

Number of Probes

2

Safety Category Level

CAT I

Safety Category Voltage

±60V

Safety Category

CAT I ±60V

COO (Country of Origin):
TW

Pico Technology Oscilloscope Probe


The Pico Technology TA044 active differential oscilloscope probe is suitable for high-speed measurement applications with a differential measurement range of ±20V and a common-mode range of up to ±60V. It can be used with signal speeds of up to 200MHz. This differential probe extends the functionality of standard single-ended input oscilloscopes to allow a safe and accurate method of making high voltage differential measurements.

Features and Benefits


• Bandwidth is DC to 200MHz (-3dB)
• Attenuation ratio is 10:1
• Accuracy is ±1%
• Input impedance is 500Kohm ll7pF each side to ground
• Differential range is ±20V
• Common mode range is ±60V
• Absolute maximum voltage (either input to ground) is ±60V
• Swing is ±2V into 50ohm load
• Offset (typical) is <±2mV
• Noise (typical) is 0.3mV RMS
• Source impedance is 50ohm
• CMRR (typical) is 80dB at 100Hz and 50dB at 10MHz
• Ambient operating temperature ranges between -10°C and 40°C
• Power requirement is 4xAA cells or 6VDC/90mA mains adaptor or regulated 9VDC/40mA mains adaptor

Applications


• Safe measurement in power circuit
• Acquisition of low-speed balanced differential signals found in serial communications buses
• Telecom measurement
• xDSL,
• high-speed power measurement and differential transmitter and receiver design.

Certifications


• IEC-1010.1
• IEC-1010.2-031 CAT III
• Pollution Degree 2.

relaterade länkar