Electromen OY DC Motor Controller, 10 → 35 V, 15 A, 35 V

Se alla Motor Controllers

Antal (1 enhet)*

1 487,80 kr

(exkl. moms)

1 859,75 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • 9 enhet(er) är redo att levereras
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
1 +1 487,80 kr

*vägledande pris

RS-artikelnummer:
183-7332
Tillv. art.nr:
EM-241B-PLI
Tillverkare / varumärke:
Electromen OY
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Electromen OY

Supply Voltage

10 → 35 V

Current Rating

15 A

Voltage Rating

35 V

COO (Country of Origin):
FI

Electromen - EM-241PLI DC MOTOR POSITION CONTROLLER, 12-24 V DC, 15 A


The EM-241-PLI is a full bridge brushed DC-motor starter.It is designed to work in a wide range of applications and offers a host of adjustments to optimise control for each application.The drive has adjustable acceleration and deceleration ramps to produce smooth starts and stops,adjustable current limit protects motor against overcurrent and can also be used to provide an end-stop on current trip

The PLI version has a PULSE COUNTER which can be used to define end stops - the count setting is stored in non-volatile memory

This device has also two settable speeds, which are useful in positioning applications

Control inputs are present for basic forward, backward and stop commands, as well as limit switch inputs to define end stops

This device has also two settable speeds, this can be activated by dedicated input. The same input can be used for analogue speed control signal 0-5V

Fault output can indicate current trip, over-current or zero-current conditions. It can also be pulled down to ground to disable the drive, if required

C-version includes wo new parameter: freewheel options for release the rotor of motor, selectable pwm frequency (16kHz pwm being inaudible though current handling capacity is reduced)

There are two selectable control modes, in continuous mode the motor runs as long as the control is active, in impulse mode it will operate from a momentary command

Special settings are also available for start-up kick and auto reverse

For parameters setting there are 3 options: EM-236 interface unit, EM-268 with Menthol-Lite PC-program and EM-326 with Menthol-App application for smartphone;Small size with high current output

2ch pulse counter inputs

Pulse counter limits.

Current limit 0.1-20A (30A at start up)

Zero current limit

Overvoltage brake

Speed setting

Flexible control inputs

impulse / continuous mode

DIN rail mountable

Programmable parameters to suit application

* Continuous current output when ambient temp is <50°C )

15A at 100% speed / 10A at 5-99% speed pwm=2kHz

Peak ( 5s.) 30A at 2khz PWM

relaterade länkar