Sauter Hårdhetsprovare Digital

Se alla Hårdhetsmätare

Antal (1 enhet)*

15 405,25 kr

(exkl. moms)

19 256,56 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • 1 enhet(er) är redo att levereras från en annan plats
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
1 +15 405,25 kr

*vägledande pris

RS-artikelnummer:
899-7977
Tillv. art.nr:
HN-D
Tillverkare / varumärke:
Sauter
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Varumärke

Sauter

Produkttyp

Hårdhetsprovare

Shore-skala

Shore D

Vikt

160g

Skärmtyp

Digital

Total längd

147mm

Standarder/godkännanden

DIN, ASTM

COO (ursprungsland):
CN

HN-D Digital Hardness Tester


The HN-D Pen style Leeb Hardness Tester from Sauter. Offering advanced features, ideal for a wide range of applications.

The Hardness Tester works by accelerating the internal bounce module against the tested item. Depending on object hardness, the kinetic energy of the module is absorbed. Speed reduction is measured and converted to hardness values.

User-friendly operation

LCD display

360° Measurement directions possible

Measurement value display

Internal data memory

USB data output

Mains or battery powered

Parallels, Surface Finish & Hardness


Surface Finish

Any machined component has a surface geometry which consists of three basic elements:

Form or Curvature - Whether the surface has irregular bumps or dimensional changes

Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)

Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)

Waviness and roughness are traditionally the most difficult elements to measure when comparing surface finish, however, they have a radical effect on the performance of the finished component. Variations will cause aesthetic appearance changes, component wear variations, oil retention variation etc. Many manufacturers therefore specify a range of roughness values which their components should be manufactured to, often expressed as: Ra, Rq (RMS), RzDIN, Ry, Sm,mm.

Relaterade länkar