onsemi NB7NPQ1002MMTTWG, USB Controller, 2-Channel, 10Gbit/s, USB 3.1, 3.3 V, 30-Pin WQFN

Se alla USB Interface ICs
För närvarande inte tillgänglig
Vi vet inte om den här artikeln kommer tillbaka i lager, RS har för avsikt att ta bort den från vårt utbud snart.
RS-artikelnummer:
195-2478
Tillv. art.nr:
NB7NPQ1002MMTTWG
Tillverkare / varumärke:
onsemi
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

onsemi

Number of Transceivers

2

Data Rate

10Gbit/s

Protocols Supported

USB 3.1

IC Type

Controller IC

Power Supply Type

Single

ESD Protection

Yes

Typical Single Supply Voltage

3.3 V

Mounting Type

Surface Mount

Package Type

WQFN

Pin Count

30

Dimensions

4.6 x 2.6 x 0.75mm

Height

0.75mm

Length

4.6mm

Maximum Operating Temperature

+85 °C

Minimum Operating Temperature

-40 °C

Width

2.6mm

The NB7NPQ1002M is a high performance single−Port linear redriver designed for USB 3.1 Gen 1 and USB 3.1 Gen 2 applications that supports both 5 Gbps and 10 Gbps data rates. Signal integrity degrades from PCB traces, transmission cables, and inter−symbol interference (ISI). The NB7NPQ1002M compensates for these losses by engaging varying levels of equalization at the input receiver, and flat gain amplification on the output transmitter. The NB7NPQ1002M offers programmable equalization and flat gain to optimize performance over various physical mediums. The NB7NPQ1002M contains an automatic receiver detect function which will determine whether the output is active. The receiver detection loop will be active if the corresponding channel’s signal detector is idle for a period of time. The channel will then move to Unplug Mode if a load is not detected, or it will return to Low Power Mode (Slumber mode) due to inactivity. Both the channels are independent with individual controls.

relaterade länkar