Infineon CY7C65632-48AXCT, Controller IC, 4-Channel, 5 V, USB 2.0, 5 V, 48-Pin TQFP

Se alla USB Interface ICs

Antal (1 förpackning med 3 enheter)*

87,09 kr

(exkl. moms)

108,87 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • Dessutom levereras 1 974 enhet(er) från den 16 januari 2026
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
Per förpackning*
3 +29,03 kr87,09 kr

*vägledande pris

Förpackningsalternativ:
RS-artikelnummer:
181-7632
Tillv. art.nr:
CY7C65632-48AXCT
Tillverkare / varumärke:
Infineon
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Infineon

Number of Transceivers

4

Product Type

Controller IC

Sub Type

Controller

USB Specification

USB 2.0

Power Supply Type

Single

ESD Protection

Yes

Minimum Supply Voltage

5V

Maximum Supply Voltage

5V

Mount Type

Surface

Package Type

TQFP

Pin Count

48

Minimum Operating Temperature

0°C

Supported Protocols

USB 2.0

Maximum Operating Temperature

70°C

Height

1.4mm

Series

CY7C65632

Standards/Approvals

No

Width

7 mm

Length

7mm

Supply Current

105.4mA

Automotive Standard

No

High performance, low-power USB 2.0 Hub, optimized for low cost designs with minimum Bill-of-material

USB 2.0 hub controller

Compliant with USB 2.0 specification, TID# 30000060

Up to four downstream ports support

Downstream ports are backward compatible with FS, LS

Single transaction translator (TT) for low cost

Very low power consumption

Supports bus-powered and self-powered modes

Auto switching between bus-powered and self-powered

Single MCU with 2K ROM and 64 byte RAM

Lowest power consumption

Highly integrated solution for reduced BOM cost

Internal regulator single power supply 5 V required

Provision of connecting 3.3 V with external regulator

Integrated upstream pull-up resistor

Integrated pull-down resistors for all downstream ports

Integrated upstream/downstream termination resistors

Integrated port status indicator control

12 MHz +/500 ppm external crystal with drive level 600 μW (integrated PLL) clock input with optional 27/48 MHz oscillator clock input

Internal power failure detection for ESD recovery

Downstream port management

Support individual and ganged mode power management

Overcurrent detection

Two port status indicators per downstream port

Maximum configurability

VID and PID are configurable through external EEPROM

Number of ports, removable/non-removable ports are configurable through EEPROM and I/O pin configuration

I/O pins can configure gang/individual mode power switching, reference clock source and polarity of power switch enable pin

Configuration options also available through mask ROM Available in space saving 48-pin (7 x 7 mm) TQFP and 28-pin 5 x 5 mm) QFN packages Supports 0 °C to 70 °C temperature range

relaterade länkar