Telemecanique Sensors XY2CE Rope Pull Switch, 70m, NO/NC

Se alla Rope Pull Switches

Antal (1 enhet)*

5 991,97 kr

(exkl. moms)

7 489,96 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • 1 enhet(er) är redo att levereras
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
1 +5 991,97 kr

*vägledande pris

RS-artikelnummer:
130-0879
Tillv. art.nr:
XY2CE6A270
Tillverkare / varumärke:
Telemecanique Sensors
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Telemecanique Sensors

Normal State Configuration

NO/NC

Cable Length

70m

IP Rating

IP66

Number of Poles

DPST

Series

XY2CE

Range

Preventa XY2

Length

229mm

Width

105mm

Depth

142mm

Housing Material

Stainless Steel

Maximum Operating Temperature

+70°C

Conduit Entry

PG13.5

Dimensions

229 x 105 x 142mm

Maximum AC Voltage

240V

Minimum Operating Temperature

-25°C

Standards Met

CCC, CSA, CSA C 22-2, EAC, EN/IEC 60947-5-5, UL (NISD), UL 508

Maximum DC Voltage

250V

Telemecanique XY2CE & XY2CB Emergency Stop Rope Pull Switches


These emergency stop trip wire switches are designed to reduce the risk of injury to persons and damage either to machines or work in progress. They can be tripped by a single human action when a normal emergency stop function is not available and will also trip in the event of the trip wire breaking.

Switches incorporate positive opening operation contacts, the tripping of the switch being made with positive action
The switch latches in the tripped position (N/C safety contact(s) open). The function of the N/O contact is purely for signalling
Incorporates a reset button, which re-closes the safety contact(s), restarting of the machine must only be achieved by manual operation of a control device within the machine start circuit, remote to the trip wire switch
Recommended distance between cable supports is 15m (for model XY2-CB30 a distance of 20m is recommended)
The XY2 CE1A296 comes with a pilot light (direct supply)

Note

The XY2 CB switch must not be used if the installation requires that the trip wire be angled but the XY2 CE switch can. In this case, the total sum of the angles through which the trip wire bends must not exceed 180°.

Standards

EN/ISO 13850:2006

relaterade länkar