Infineon Development Board Flyback Converter for ICL8820 for LED Lighting Applications

Two-stage topologies are growing because of the convenient scalability of power on the primary side as well as of the features on the secondary side. REF_ICL8820_LED_43W_JT is designed as plug- and-play solution.

As a default setup, the reference design board is assembled with a start-up circuit based on a depletion-mode MOSFET BSS126I on a very small adapter board. This setup offers the lowest standby losses. If low standby consumption is not necessary as an option, the start-up circut can be changed to a resistive start-up.

This reference design is provided with two regulation circuits. Both circuits are designed as plug and play solutions, but at least one has to be connected to the main board.

The two boards shall show the trade-off between cost; here the TL431 board offers a low-cost solution, and standby performance, while the op-amp board shows an overall 30mW better performance.

Being the fully-featured variant of the ICL88xx family, ICL8820 is the perfect fit for on-off LED drivers, low dimming down to 0.1% including dim-to-off. Additionally equipped with an integrated burst mode and jitter function, the controller enables a very low stand-by power < 100mW. The built-in jitter function eases EMI certification without additional circuitry. Thus, ICL8820 is perfect for smart lighting and additionally eases the design of emergency lighting LED drivers at low cost and effort.

To scale the features according to your application and needs, check out ICL8800, ICL8810 and the respective boards:

•REF_ICL8800_LED_43W

•REF_ICL8810_LED_43W_BM

For primary-side regulation of the single-stage flyback LED controller-family ICL88xx, choose REF_ICL8810_LED_42W_PSR.

•ICL8820 provides integrated burst mode for very low stand-by power < 100mW and built-in jitter function for easy EMI certification without additional circuitry

•Power factor (PF) > 0.9 and THD < 10% across a wide load range (AC input up to 277Vrms)

•Maximum AC input voltage 90 – 305Vrms

•Critical conduction mode and quasi-resonant mode with smart valley hopping

•Enables smart lighting and emergency lighting

•Two-stage topology combines scalability with numerous features

•High light quality

•Cost effective and bottom-up design

•Flexibility and low BOM for many applications

•800V CoolMOS™ P7 superjunction MOSFET (IPD80R900P7)

•600V N-Channel small signal depletion-mode MOSFET (BSS126I)