Microchip, 8 bit AVR, ATMEGA32U2 Microcontroller, 16 MHz, 32kB FLASH, 32-Pin TQFP

Mängdrabatt möjlig

Antal 10 enheter (levereras på en bricka)*

406,00 kr

(exkl. moms)

507,50 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • Dessutom levereras 334 enhet(er) från den 15 december 2025
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
10 - 2240,60 kr
24 - 9839,535 kr
100 +38,585 kr

*vägledande pris

Förpackningsalternativ:
RS-artikelnummer:
131-0287P
Tillv. art.nr:
ATMEGA32U2-AU
Tillverkare / varumärke:
Microchip
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Microchip

Series

ATMEGA32U2

Product Type

Microcontroller

Package Type

TQFP

Mount Type

Surface

Pin Count

32

Device Core

AVR

Data Bus Width

8bit

Program Memory Size

32kB

Interface Type

SPI, USART

Maximum Clock Frequency

16MHz

RAM Size

1kB

Maximum Supply Voltage

5.5V

Minimum Operating Temperature

-40°C

Analogue Comparators

1

Number of Programmable I/Os

22

Maximum Operating Temperature

85°C

Standards/Approvals

No

Length

7mm

Height

1.05mm

Width

7 mm

Minimum Supply Voltage

2.7V

Number of Timers

2

Program Memory Type

FLASH

Distrelec Product Id

304-37-096

Automotive Standard

No

Instruction Set Architecture

RISC

ADCs

0 bit

The Microchip ATmega32U2 CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. It operates on 2.7V to 5.5V voltage range. The AVR core combines a rich instruction set with 32 general purpose working registers. It features 32Kbytes of In-System Programmable Flash with Read-While-Write capabilities, 1024 bytes EEPROM, 1024 bytes SRAM 22 general purpose I/O lines, 32 general purpose working registers, two flexible Timer/Counters with compare modes and PWM, one USART, a programmable Watchdog Timer with Internal Oscillator, an SPI serial port, debugWIRE interface, also used for accessing the On-chip Debug system and programming and five software selectable power saving modes. The Idle mode stops the CPU while allowing the SRAM, Timer/Counters, SPI port, and interrupt system to continue functioning. The Power-down mode saves the register contents but freezes the Oscillator, disabling all other chip functions until the next interrupt or hardware reset.

Up to 16 MIPS Throughput at 16 MHz

In-System Programming by on-chip Boot Program hardware-activated after reset

Programming lock for software security

USB 2.0 Full-speed device module with interrupt on transfer completion

Microcontroller reset on USB Bus Reset without detach

USB Bus Disconnection on Microcontroller Request

One 8-bit Timer/Counters with Separate Prescaler and Compare Mode (two 8-bit PWM channels)

One 16-bit Timer/Counter with Separate Prescaler, Compare and Capture Mode (three 8-bit PWM channels)

Master/Slave SPI Serial Interface

Programmable watchdog timer with separate on-chip oscillator

On-chip analog comparator

Interrupt and wake-up on pin change

Power-On Reset and programmable brown-out detection

Internal calibrated oscillator

External and internal Interrupt sources

QFN32 (5x5mm) / TQFP32 package