Specifikationer

Datablad

Lagstiftning och ursprungsland

Produktdetaljer

Hitta liknande produkter genom att välja ett eller flera attribut.

Välj alla	Attribut	Värde
	Brand	GET
	Primary Voltage Rating	230 → 240V ac
	Secondary Voltage Rating	11.4 → 11.6V ac
	Dimensions	206 x 56 x 44 mm
	Length	206 mm
	Width	56 mm
	Depth	44 mm
	Minimum Load Requirement	70W
	Weight	300 g
	Type	Electronic
	Dimming	Dimming
	Dimming Method	Trailing Edge
	Primary Current Rating	17.4
	Maximum Operating Frequency	50Hz

	Välj alla
	Brand GET
	Primary Voltage Rating 230 → 240V ac
	Secondary Voltage Rating 11.4 → 11.6V ac
	Dimensions 206 x 56 x 44 mm
	Length 206 mm
	Width 56 mm
	Depth 44 mm
	Minimum Load Requirement 70W
	Weight 300 g
	Type Electronic
	Dimming Dimming
	Dimming Method Trailing Edge
	Primary Current Rating 17.4
	Maximum Operating Frequency 50Hz

Lighting Technical information

COO (Country of Origin):: CN

Low Voltage Lighting Transformers

Dimming Methods (where applicable):
Leading Edge:
The control device is either a thyristor or triac which blocks power until they are switched on by the control signal. At that point the current flows almost instantaneously and continues to flow until the end of the half cycle of the mains waveform. When the signal reaches zero, the device turns off and no more current is passed until it is triggered again. Turning the power on and off in this manner averages out creating a constant intensity level and by altering the precise trigger point over a period of time the lamp can be dimmed.

Trailing Edge:
Since this method of dimming uses transistor technology it is not limited to just switching, therefore current can be controlled gradually. Transistors can be programmed to pass current at the start of each half cycle, and gradually switch off later. This will control the full amount of power reaching the lamp without the side effects of a step increase in current.

GET Lighting Transformer, 230 → 240V ac, 11.4 → 11.6V ac

Alternativ

relaterade länkar