Cynergy3, 0.9 L/min Flow Controller, Cable, Relay

Cynergy3 Flow Detection Switch

The Cynergy3 flow detection switch has a maximum flow rate of 0.90L/min designed for use in liquid flow systems at pressures up to 10bar and temperatures up to 85°C. Its design is based around a moving magnet and a fixed reed switch with a low flow restriction. This switch is designed to be used in liquids only and should not be used in systems with significant amounts of solid particles. This flow switch can be mounted horizontally or vertically and has minimal flow restriction. It is ideally used in water but can be used in weak acidic liquids.
Note:
Not to be used in any chlorinated liquids

Features and Benefits

15mm and 22mm tube versions
Low flow version available in a 15mm tube
Release flow rate is 0.25L/min
Use in cold and hot water up to 85°C
Mainly for use with hot or cold water however, they may also be used with a wide range of chemicals
Pressure rating is 150psi maximum
Switching current is 1A DC or AC (rms)
Switching voltage is 240V DC or AC (rms)
Switching power is 15W (15VA) resistive loads

Applications

Flow measurement and dosing control
Industrial use

Certifications

WRAS approved