Sauter HB0 100-0HB0 100-0. Durometer

Se alla Durometers

Antal (1 enhet)*

1 760,94 kr

(exkl. moms)

2 201,18 kr

(inkl. moms)

Add to Basket
välj eller skriv kvantitet
I lager
  • 6 enhet(er) är redo att levereras
  • Plus 2 enhet(er) är redo att levereras från en annan plats
Behöver du mer? Ange den kvantitet du behöver och klicka på "Kontrollera leveransdatum"
Enheter
Per enhet
1 +1 760,94 kr

*vägledande pris

RS-artikelnummer:
136-3545
Tillv. art.nr:
HB0 100-0
Tillverkare / varumärke:
Sauter
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Sauter

Shore Scale

Shore A0

Tester Type

Durometer

Indenter

Ball Head

Graduation

1

Weight

160g

Dimensions L x W x D

115 x 60 x 25mm

COO (Country of Origin):
CN

Kern Analogue Shore Hardness Tester


A compact hand held durometer with drag indicator. Ideal for internal comparison measurement. Supplied in a wooden carrying case for safe and secure storage.

Typical Application


• Measurement of penetration (Shore)

Feature and Benefits


• Mechanical shore hardness meter;• For internal comparison measurement. Standard calibrations e.g. to DIN 53505 are often not possible because of narrow standard tolerances;• Shore A: Rubber, elastomers, neoprene, silicone, vinyl, soft plastics, felt, leather and similar material;• Shore D: Plastics, Formica, epoxies, plexi glass etc.;• Shore A0: Foam, sponge etc.;• Max Mode: Holds the maximum value in the display;• Point Mode: Shows one instant value;• Can be attached to test stands SAUTER TI-A0 (for Shore A and A0), TI-D. (for Shore D);• Tester Shore A0

Parallels, Surface Finish & Hardness


Surface Finish

Any machined component has a surface geometry which consists of three basic elements:

Form or Curvature - Whether the surface has irregular bumps or dimensional changes

Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)

Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)

Waviness and roughness are traditionally the most difficult elements to measure when comparing surface finish, however, they have a radical effect on the performance of the finished component. Variations will cause aesthetic appearance changes, component wear variations, oil retention variation etc. Many manufacturers therefore specify a range of roughness values which their components should be manufactured to, often expressed as: Ra, Rq (RMS), RzDIN, Ry, Sm,mm.

Relaterade länkar