Microchip MCP2551-E/P, CAN Transceiver 1Mbps ISO 11898, 8-Pin PDIP

Se alla CAN Interface Ics
För närvarande inte tillgänglig
Vi vet inte om den här artikeln kommer tillbaka i lager, RS har för avsikt att ta bort den från vårt utbud snart.
RS-artikelnummer:
177-1626
Tillv. art.nr:
MCP2551-E/P
Tillverkare / varumärke:
Microchip
Hitta liknande produkter genom att välja ett eller flera attribut.
Välj alla

Brand

Microchip

Maximum Data Rate

1Mbps

Number of Transceivers

1

Standard Supported

ISO 11898

IC Type

CAN Transceiver IC

Maximum Supply Current

75 mA

Mounting Type

Through Hole

Package Type

PDIP

Pin Count

8

Dimensions

0.4 x 0.28 x 0.19in

Length

10.16mm

Width

7.11mm

Height

4.83mm

Maximum Operating Supply Voltage

5.5 V

Minimum Operating Supply Voltage

4.5 V

Maximum Operating Temperature

+125 °C

Minimum Operating Temperature

-40 °C

COO (Country of Origin):
US

Microchip Technology CAN Transceiver


The Microchip technology 1 channel, 1Mbit/s CAN transceiver has 8 pins and PDIP package type. This device is a high speed CAN, fault-tolerant device that serves as the interface between a CAN protocol controller and the physical bus. The Local Interconnect Network (LIN) bus supports communication in automotive networks.

Features and Benefits


• An unpowered node or brown out event will not disturb the CAN bus
• Automatic thermal shutdown protection
• Detection of ground fault (permanent dominant) on TXD input
• Externally controlled slope for reduced RFI emission
• High noise immunity due to differential bus implementation
• Implements ISO-11898 standard physical layer requirements
• Low current stand by operation
• O extended (E):-400C to 1250C
• O industrial (I):-400C to 850C
• Power on reset and voltage brown out protection
• Protection against damage due to short circuit conditions (positive or negative battery voltage)
• Protection against high voltage transients
• Suitable for 12V and 24V systems
• Temperature ranges
• Up to 112 nodes can be connected

relaterade länkar