United Automation, STOM-1, Thyristor Trigger Module, 18V ac, 93 x 62 x 44mm

Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
COO (Country of Origin): GB
Produktdetaljer

Phase Angle & Burst Firing Single-Phase, STOM-1

A solid state, microprocessor based device incorporating both Phase Angle and Burst Firing modes of power control (selectable).

Capable of controlling loads up to 25A at voltages up to 415 Vac
Can also be used for soft starting in Phase Angle and will automatically switch to Burst Firing at a preset signal level, remaining there even if the signal falls below preset level
18 Vac supply
0 to 30s adjustable ramp-up from cold
Control input 0 to 5V or 4-20mA current loop
Can be controlled by a temperature controller or PC

Note

Mount on an adequate heat sink (heat sink compound stock no. 554-311 recommended). To comply with BSEN55014 in Phase Angle mode, a line filter should be used.

//media.rs-online.com/t_line/L195352-01.gif

The number of complete mains cycles during fixed repeating periods (typically 1 to 10 seconds) is varied, thus altering the duty cycle or on-/off-time ratio. Trigger pulses coincide with the zero-crossing times of the mains supply thus ensuring no RFI is produced when using resistive loads.

Specifikationer
Attribute Value
Input Voltage AC 18V ac
Output Isolation 3500V
Mounting Type Screw Mount
Dimensions 93 x 62 x 44mm
Length 93mm
Height 44mm
Maximum Input Logic Voltage 440V
Width 62mm
Maximum Operating Temperature +65 °C
Minimum Input Logic Voltage 5V
Minimum Operating Temperature 0 °C
6 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
1 270,68 kr
(exkl. moms)
1 588,35 kr
(inkl. moms)
Enheter
Per unit
1 - 1
1 270,68 kr
2 - 4
1 220,02 kr
5 - 9
1 171,21 kr
10 - 19
1 124,48 kr
20 +
1 079,50 kr
Related Products
SCR trigger modules for use in zero voltage ...
Description:
SCR trigger modules for use in zero voltage (SKPC 100Z), or instantaneous (SKPC 100) applications. Uses a hard firing technique to eliminate the need for an external transformer. Triggers SCRs in dc bridge configurationsPolarised Faston connectorsMounting centres identical to SCR ...
Variable, manually controlled, phase angle regulator for use ...
Description:
Variable, manually controlled, phase angle regulator for use with direct or transformer coupled, single phase loads. Mounted on integral heat sinkReversible base allows surface/panel mountingLarge Triac handles high inrush currentsSuitable for use with conventional heaters, quartz or tungsten lamps.
Phase angle trigger module for resistive & inductive ...
Description:
Phase angle trigger module for resistive & inductive loads. The MONO-LINK firing system is ideal for use with inductive loads via triac or thyristor on single phase-to-neutral, phase-to-phase supplies. Remote power transformer for increased reliability and wide operational voltage capacityMONO-LINK® ...
Single phase burst firing modules for driving triacs ...
Description:
Single phase burst firing modules for driving triacs and thyristors with resistive loads. Fires triacs & thyristors up to 440VRFI free, zero voltage switchingSelectable soft-start functionOpto-coupled outputMONO-LINK® gate-to-gate firingVoltage control or 4-20mA current loopAuxiliary 5Vdc output for manual ...