Figaro EM8100, Gas Sensor Evaluation Module for TGS8100

  • RS-artikelnummer 134-6636
  • Tillv. art.nr EM8100
  • Tillverkare / varumärke Figaro
Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
Produktdetaljer

Evaluation Module for TGS8100 Air Quality Sensor

A PCB module from Figaro which allows evaluation of the on-board TGS8100 air quality sensor. Operation is simplified by using a continuous output signal generated by the module. Although the TGS8100 operating mode uses intermittent detection via a 1-second cycle, the periodic sensor output is converted into a continuous voltage signal by the module's microprocessor. The TGS8100 sensor is mounted on a replaceable daughter-board and is sensitive to most common air contaminant gases. The module requires a regulated supply of 5Vdc and produces an output of 0-3V.

PCB Mounted Gas Sensors

Operating conditions in which Sensors are used will vary with each customer's application. Gas and oxygen sensors are not authorised for use as critical components in life support applications wherein a failure or malfunction of the products may result in injury or threat to life. Non-calibrated PCB gas sensors will not operate properly if not calibrated prior to usage.

Semiconductor gas sensors for gas detection, air quality control, HVAC, appliance and automotive industries. Characteristics of the products in this range are small size, low cost, long life, low power consumption and no maintenance requirement

Specifikationer
Attribute Value
Sensor Technology Gas Sensor
Featured Device TGS8100
Kit Classification Evaluation Module
8 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
2 017,33 kr
(exkl. moms)
2 521,66 kr
(inkl. moms)
Enheter
Per unit
1 - 4
2 017,33 kr
5 +
1 950,02 kr
Related Products
The USB2.0 Hi-Speed to MPSSE SPI Module, VA800A-SPI, ...
Description:
The USB2.0 Hi-Speed to MPSSE SPI Module, VA800A-SPI, is a small electronic circuit board, utilising the FTDI FT232H. The 10 pin connector on the module fits directly to the FTDI VM800B and VM800C graphic display modules. This allows direct control ...
These modules are MCU to USB host controller ...
Description:
These modules are MCU to USB host controller development modules for the Vinculum VNC1L device. They are supplied on a PCB designed to fit into 24-pin or 40-pin DIP sockets and provide access to the UART, parallel FIFO and SPI ...
The MCP2200 Breakout Module allows for the evaluation ...
Description:
The MCP2200 Breakout Module allows for the evaluation and development of the MCP2200 serial converter. Dual In-Line Package (DIP) Form Factor BoardUART Tx and Rx signalsUART RTS and CTS signals8 General Purpose (GP) linesUser selectable power supply of 3.3 V ...
The PmodUSBUART provides a seamless bi-directional link between ...
Description:
The PmodUSBUART provides a seamless bi-directional link between a USB bus and a UART serial bus. It is based on the FT232RQ Bridge device. • MicroUSB connector• Powered from USB connection• Jumper link option to power system board from Pmod ...