STR1 RFID Safety Switch, Vistal, 24 V dc

  • RS-artikelnummer 146-6218
  • Tillv. art.nr STR1-SAMU0AC5
  • Tillverkare / varumärke Sick
Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
COO (Country of Origin): MY
Produktdetaljer

the Str1 transponder safety switch has monitored semiconductor outputs (oSSds) and can be safely connected either individually or in series. It can be used for applications where a high level of manipulation protection is required. the Str1 is available with three codes. universally coded sensors accept all actuators. an actuator must be taught into both the uniquely coded and permanently coded variants, this is the only actuator that the Str1 then accepts. the sensor has three active sensor surfaces. the actuator comes in three different sizes. this allows the Str1 to offer maximum mounting flexibility.

response range of up to 14 mm
Small housing with flexible mounting
options
Sensor activation possible from three
sides
three different actuators available

Specifikationer
Attribute Value
Supply Voltage 24 V dc
Housing Material Vistal
Auxiliary Contacts 1
Connection Type 5­Pin M12 Plug
Switch Type Safety
Terminal Type 0.2m cable with 5-Pole M12 Connector
Series STR1
Switching Distance 9 (Side Sensor - On) mm, 14 (Front Sensor - On) mm, 28 (Off) mm
IP Rating IP67
Supply Current 50 mA
Actuator Included Yes
Number of Approach Directions 5
Actuator Type Mini
Built in Safety Relay Yes
Depth 40mm
Width 26.2mm
Sensor Principle RFID
Safety Category Category 4 (EN ISO 13849), PL e (EN ISO 13849), SIL3 (IEC 61508), SILCL3 (EN 62061)
Dimensions 18 x 26.2 x 40 mm
Standards Met CE, CULus, EN 62061, FCC, IEC 61508
Length 18mm
1 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
1 468,28 kr
(exkl. moms)
1 835,35 kr
(inkl. moms)
Enheter
Per unit
1 +
1 468,28 kr
Related Products
The Allen Bradley Guardmaster SensaGuard non-contact switch uses ...
Description:
The Allen Bradley Guardmaster SensaGuard non-contact switch uses the latest generation of RFID technology for coding and inductive technology for sensing. SensaGuard’s large sensing range and tolerance to misalignment is a cost-effective solution that is ideally suited for a wide ...
The SensaGuard Non-Contact Switch is PLe, SIL 3 ...
Description:
The SensaGuard Non-Contact Switch is PLe, SIL 3 and Cat 4 rated and is intended for use with sliding, hinge or lift-off machine guard doors. These safety switches are based on RFID (Radio Frequency IDentification) technology for coding and inductive ...
The Telemecanique Sensors XCSDM series safety switch is ...
Description:
The Telemecanique Sensors XCSDM series safety switch is magnetically coded. The built-in safety relay enables the switch to self-check and detects its failure without the use of an external safety relay. It can directly drive external contactors to directly and ...
The Telemecanique Sensors XCS-DMC series magnetic safety switch ...
Description:
The Telemecanique Sensors XCS-DMC series magnetic safety switch has 5mm tolerance to misalignment. This means that it can protect the operator by immediately stopping any dangerous movement as soon as the distance between the switch and its magnet is greater ...