STMicroelectronics L298P, Brushed Dual Full Bridge Motor Driver, 46 V 4A 20-Pin, PowerSO

Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
Produktdetaljer

L298 Dual Full Bridge Motor Driver

ST Microelectronics presents its L298 dual full bridge driver series. The L298 series from ST is an integrated high voltage, high current dual full bridge driver. These devices are specially designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that allow the L298 to be enabled or disabled independently of the input signals. The emitters of the lower transistors of each bridge are connected together, the corresponding external terminal can be used to connect an external sensing resistor. In addition, a supply input is provided so that the logic works at a lower voltage.

Features

  • Operating supply voltage up to 46 V

  • Total DC current of up to 4 A

  • Low saturation voltage

  • Over-temperature protection

  • Logical "0" input voltage up to 1.5 V (high noise immunity)

What are Motor Driver IC's?

Motor Driver ICs are current amplifiers and are an essential component of motor interfacing. The motor driver integrated circuit chip acts as the interface between a microprocessor or microcontroller, and a motor. As microprocessors tend to operate at lower currents, and motors at higher, motor driver ICs are needed to supply current to the motor as needed. The RS Components range of Motor Driver ICs includes models from leading brands, in various types and configurations to support your design needs.

Motor Controllers & Drivers, STMicroelectronics

Specifikationer
Attribute Value
Motor Type Brushed DC
Output Configuration Dual Full Bridge
Maximum IGBT Collector Current 4A
Maximum Collector Emitter Voltage 46 V
Mounting Type Surface Mount
Package Type PowerSO
Pin Count 20
Maximum Operating Supply Voltage 46 V
Minimum Operating Supply Voltage 4.8 V
Inverter Power Rating 25W
Minimum Operating Temperature -25 °C
Length 16mm
Height 3.6mm
Width 11.1mm
Maximum Operating Temperature +130 °C
Dimensions 16 x 11.1 x 3.6mm
31 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each (In a Tube of 31)
45,89 kr
(exkl. moms)
57,36 kr
(inkl. moms)
Enheter
Per unit
Per Tube*
31 - 31
45,89 kr
1 422,59 kr
62 - 93
43,598 kr
1 351,538 kr
124 - 279
39,786 kr
1 233,366 kr
310 - 589
38,038 kr
1 179,178 kr
620 +
34,783 kr
1 078,273 kr
Related Products
The HIP2103-4DEMO1Z Demonstration Board, is a general purpose ...
Description:
The HIP2103-4DEMO1Z Demonstration Board, is a general purpose motor drive module with a microprocessor controller on-board. It uses a PIC microcontroller to control the HIP2103 and the HIP2104 half bridge drivers with six MOSFETs.The HIP2103-4DEMO2Z Demonstration Board integrates the HIP2103 ...
The device is a full bridge motor driver ...
Description:
The device is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. Both switches are designed using STMicroelectronics’ well known and proven proprietary VIPower®M0 ...
The device is a full bridge motor driver ...
Description:
The device is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. All switches are designed using STMicroelectronics® well known and proven proprietary VIPower® ...
STMicroelectronics has extended its offering of IGBT intelligent ...
Description:
STMicroelectronics has extended its offering of IGBT intelligent power modules with the introduction of the second series of SLLIMM intelligent power modules. Thanks to the optimal trade-off between conduction and switching energy, combined with outstanding robustness and EMI behaviour, they ...