STMicroelectronics L298P, Brushed Dual Full Bridge Motor Driver, 46 V 4A 20-Pin, PowerSO

Lagstiftning och ursprungsland

L298 Dual Full Bridge Motor Driver

ST Microelectronics presents its L298 dual full bridge driver series. The L298 series from ST is an integrated high voltage, high current dual full bridge driver. These devices are specially designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that allow the L298 to be enabled or disabled independently of the input signals. The emitters of the lower transistors of each bridge are connected together, the corresponding external terminal can be used to connect an external sensing resistor. In addition, a supply input is provided so that the logic works at a lower voltage.


  • Operating supply voltage up to 46 V

  • Total DC current of up to 4 A

  • Low saturation voltage

  • Over-temperature protection

  • Logical "0" input voltage up to 1.5 V (high noise immunity)

What are Motor Driver IC's?

Motor Driver ICs are current amplifiers and are an essential component of motor interfacing. The motor driver integrated circuit chip acts as the interface between a microprocessor or microcontroller, and a motor. As microprocessors tend to operate at lower currents, and motors at higher, motor driver ICs are needed to supply current to the motor as needed. The RS Components range of Motor Driver ICs includes models from leading brands, in various types and configurations to support your design needs.

Motor Controllers & Drivers, STMicroelectronics

Attribute Value
Motor Type Brushed DC
Output Configuration Dual Full Bridge
Maximum IGBT Collector Current 4A
Maximum Collector Emitter Voltage 46 V
Mounting Type Surface Mount
Package Type PowerSO
Maximum Operating Supply Voltage 46 V
Pin Count 20
Minimum Operating Supply Voltage 4.8 V
Inverter Power Rating 25W
Height 3.6mm
Width 11.1mm
Dimensions 16 x 11.1 x 3.6mm
Maximum Operating Temperature +130 °C
Length 16mm
Minimum Operating Temperature -25 °C
133 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
53,15 kr
(exkl. moms)
66,44 kr
(inkl. moms)
Per unit
1 - 4
53,15 kr
5 - 9
49,94 kr
10 - 24
47,25 kr
25 - 49
44,67 kr
50 +
42,50 kr
Related Products
The Semikron SKYPER® 12 press-fit modules are IGBT ...
The Semikron SKYPER® 12 press-fit modules are IGBT drivers for SEMIX Press-fit and Econodual Press-fit IGBT modules. The half-bridge driver boards can be mounted directly onto 17mm press-fit modules. With 30% fewer components than other plug-and-play solutions, these drivers achieve ...
Power drivers for MOSFET and IGBT in low ...
Power drivers for MOSFET and IGBT in low side, high side, and half-bridge circuits. High Voltage Range: Up to 600 VdV/dt Immunity ± 50 V/nsecGate Drive Supply Range from 10 V to 20 VHigh and Low Drive OutputsOutput Source / ...
The range of power drivers by STMicroelectronics are ...
The range of power drivers by STMicroelectronics are designed to drive a motor or a complex load through the logic commands at its input. They can be used with microcontrollers, DSPs or FPGAs in a motor or motion control system. ...