STMicroelectronics VNH7070ASTR Motor Driver IC 16-Pin, SOIC

Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
Produktdetaljer

The device is a full bridge motor driver intended for a wide range of automotive applications. The device incorporates a dual monolithic high-side driver and two low-side switches. Both switches are designed using STMicroelectronics’ well known and proven proprietary VIPower® M0-7 technology that allows to efficiently integrate on the same die a true Power MOSFET with an intelligent signal/protection circuitry. The three dies are assembled in SO-16N package on electrically isolated lead-frames. Moreover, its fully symmetrical mechanical design allows superior manufacturability at board level.

Output current: 15 A
3 V CMOS-compatible inputs
Undervoltage shutdown
Overvoltage clamp
Thermal shutdown
Cross-conduction protection
Current and power limitation
Very low standby power consumption
Protection against loss of ground and loss of VCC

Specifikationer
Attribute Value
Configuration H Bridge
Output Configuration Dual Half Bridge
Maximum Output Current 15A
Maximum Supply Voltage 41 V
Mounting Type Surface Mount
Package Type SOIC
Maximum Operating Supply Voltage 28 V
Pin Count 16
Minimum Operating Supply Voltage 4 V
Typical Switching Frequency 20kHz
Series VNH
Automotive Standard AEC-Q100
Height 1.25mm
Product Length 10mm
Maximum Operating Temperature +150 °C
Length 10mm
Dimensions 10 x 4 x 1.25mm
Product Width 4mm
Width 4mm
Minimum Operating Temperature -40 °C
Product Height 1.25mm
6 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each (In a Pack of 2)
31,90 kr
(exkl. moms)
39,88 kr
(inkl. moms)
Enheter
Per unit
Per Pack*
2 - 8
31,90 kr
63,80 kr
10 - 98
25,385 kr
50,77 kr
100 - 498
22,025 kr
44,05 kr
500 - 998
18,665 kr
37,33 kr
1000 +
15,665 kr
31,33 kr
Förpackningsalternativ:
Related Products
Description:
The STSPIN240 is a dual brush DC motor driver integrating a low RDS(ON) power stage in a small QFN 3 x 3 mm package.Both the full-bridges implement an independent PWM current controller with fixed OFF time.The device is designed to ...
Infineon offer a variety of drivers that offer ...
Description:
Infineon offer a variety of drivers that offer a solution for motor controls and drives. The selection includes Integrated Full-Bridge, Powertrain H-Bridge, TrilithIC, NovalithIC as well as Servo and Stepper motor drivers.The H-bridge is suited to applications such as DC ...
The Brushless DC Motor Drivers include power drivers ...
Description:
The Brushless DC Motor Drivers include power drivers in a 3 phase bridge configuration. The ICs integrate decoding logic for Hall-effect sensors and a PWM current controller to drive autonomously a BLDC motor with microcontroller commands.A robust and reliable electronic ...
The L298 from ST is an integrated high ...
Description:
The L298 from ST is an integrated high voltage, high current Dual Full-Bridge Driver. The device is designed to accept standard TTL logic and drive inductive loads in Relays, Solenoids, DC and Stepper Motors. Featured are two enable inputs that ...