RS PRO Emergency Light Conversion Kit for use with Emergency Lighting

If you're converting fluorescent luminaires to emergency lighting, it's essential that you do it right. This emergency light conversion kit from RS PRO is suitable for integrating into existing control gear and fits inside most modern fluorescent batten fittings.

The module can be tuned for a wide range of 4-pin (T5) fluorescent lamps. It's fitted with five pole relays to switch all four lamp connections from ballast to inverter during an emergency. The changeover circuit kicks in on failure of the unswitched supply, turning on the battery supply. It's supplied with a fused terminal block and pre-cut connection wires.

The kit meets a range of international standards, including EN 61347-2-7 as safe lamp control gear, EN 60598-2-2 as a safe luminaire and ICEL 1004 on conversion to emergency lighting. This kit can be used to convert luminaires to emergency lighting in a variety of commercial premises and public buildings.

• Emergency light conversion kit
• Length of 150 mm
• Width of 44 mm
• Height of 30 mm
• Fixing centres are 140 mm apart
• Wattage of 38 W
• Voltage rating of 220-240 V AC at 50/60 Hz
• Maximum supply current rating of 80 mA
• Maximum operating temperature of +50˚C
• Minimum operating temperature of 0˚C
• Maximum case temperature of +70˚C
• 3 A internal fuse
• Conductor size of 0.5 mm² to 1.5 mm²
• M4 mounting screws
• Meets standard EN 61347-2-7 as safe lamp control gear
• Complies with standard EN 60598-2-2 as a safe luminaire
• Conforms to CEL 1004 on conversion to emergency lighting
• Meets BS 5266-1:2005/IEC 62034 on automatic testing
• Conforms to ANSI/ESD S20.20:2014 and BS EN 61340-5-1:2007 Electrostatic Control Standards
• RoHS (Restriction of Hazardous Substances) compliant

RS PRO is our own brand range and brings you a wide range of high-quality, great value products offering you more choice. Trusted by engineers all over the world, every part of every RS PRO product has been rigorously tested against demanding industry standards they’re only given the RS PRO Seal of Approval if we’re confident of their exceptional quality, which means you can be confident too.

Nominal tube diameter - T5=16mm, T8=26mm, T12=38mm

Charger/inverter modules for converting fluorescent luminaires into emergency lighting units.,The module and battery packs fit inside most modern fluorescent batten fittings. For luminaires that have limited internal dimensions or that have internal temperatures above 50°C, remote mounting boxes are also available. The remote box is also suitable for converting double luminaires into emergency units, however only 1 tube will operate under emergency conditions. Two live supplies are required for standard operation, one switched, one unswitched. Failure of the unswitched supply operates the changeover circuit bringing on the battery supply. A red LED is supplied with the module for fitting into either the luminaire or remote box, to indicate a healthy battery charging state. The nickel-cadmium battery packs are protected against deep discharge.