Beha-Amprobe ADPTR-B22-EUR, Light Check Adapter

  • RS-artikelnummer 186-5517
  • Tillv. art.nr ADPTR-B22-EUR
  • Tillverkare / varumärke Beha-Amprobe
Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
COO (Country of Origin): CN
Produktdetaljer

Ensure safe and reliable testing of light points with the Light-Check Adapters. The adapters can be used in conjunction with a wide variety of test equipment that use test leads terminating in 4 mm safety connectors. The adapters enable a range of tests to be conducted on light fitting terminals, eliminating the need to hold test probes in place and ensure a good reliable and safe contact.

Ease of use, one-hand operation
Optimal and safe contact to light points
Low contact resistance (important for line resistance measurement)
Additional safety barrier (finger guard)
Designed in a small robust housing
4 mm safety socket
Maintenance free
Applications
Installation testers
Insulation testers
Wire tracers
Voltage measurement and monitoring (PQ)

Specifikationer
Attribute Value
Accessory Type Light Check Adapter
For Use With Installation Testers, Insulation Testers, Voltage Measurement and Monitoring (PQ), Wire Tracers
1 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
215,07 kr
(exkl. moms)
268,84 kr
(inkl. moms)
Enheter
Per unit
1 +
215,07 kr
Related Products
IR windows allow safe and effective thermal imaging ...
Description:
IR windows allow safe and effective thermal imaging of fully energised electrical systems through closed panels and doors during routine electrical maintenance / inspection. Arc flash resistant to 50 kA (IEC62271-100 and IEC62271-200)Certified to IP65 (BSEN60529) when open or closedMoisture ...
3-phase current adapter for connecting test instruments to ...
Description:
3-phase current adapter for connecting test instruments to 5-pole CEE outlets. These adapters correspond to 5-pole CEE sockets with nominal current Phase sequence testing with signal lamps Testing for effectiveness of protective measures with five 4mm contact protected sockets.
An in-line holder to connect individual components with ...
Description:
An in-line holder to connect individual components with 4mm safety test leads. Holder comprises 2x4mm safety plugs and 2x4mm safety sockets rated at 600V (CAT II)Component solder connections are provided within the screw-together adaptor casing Components clearly visible through transparent ...
Ø 4 mm safety component holder for experimental ...
Description:
Ø 4 mm safety component holder for experimental circuit board SET4.Component mounting: welded onto terminals supplied.Protection level: IP2X.Available in two-pole or four-pole versions.For use in education, research and development etc.