MCP4161-103E/P, Digital Potentiometer 10kΩ 257-Position Linear Serial-SPI 8-Pin PDIP

  • RS-artikelnummer 723-9968
  • Tillv. art.nr MCP4161-103E/P
  • Tillverkare / varumärke Microchip
Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
Produktdetaljer

MCP414x/416x/424x/426x Digital Potentiometers

The Microchip MCP413x, MCP415x, MCP423x and MCP425x range of devices are Digital Potentiometers with a SPI interface and EEPROM memory.

Featured is WiperLock Technology, providing a method of ’locking’ the wiper configuration. To unlock a high-voltage command is required (>8.5 V), protecting the setting during normal operation.

7-bit (129 steps) and 8-bit (257 steps) versions are available in various RAB resistance options from 5 kΩ to 100 kΩ. Further variants also give the choice between Rheostat and Potentiometer pinouts, Single and Dual Resistor Network options are also available.

Features

Zero Scale to Full-Scale Wiper Operation
Low Wiper Resistance: 75 Ω (typical)
Low Temperature Coefficient: Absolute (Rheostat) 50 ppm, Ratiometric (Potentiometer) 15 ppm (typical)
Automatic Recall of Saved Wiper Setting
WiperLock Technology
SPI Serial Interface
Resistor Network Terminal Disconnect Feature
Brown-Out Reset Protection: 1.5 V (typical)
Serial Interface Inactive Current: 2.5 μA (typical)
High-Voltage Tolerant Digital Inputs: Up to 12.5 V
Supports Split Rail Applications
Internal Weak Pull-Up on all Digital Inputs
Wide Operating Voltage: 1.8 V to 5.5 V
Wide Bandwidth (-3 dB) Operation: 2 MHz for 5.0 kΩ device (typical)

Model Variants

Potentiometer Wiper Configuration: MCP4141, MCP4161, MCP4241, MCP4261
Rheostat Wiper Configuration: MCP4142, MCP4162, MCP4242, MCP4262

Single Resistor Network: MCP4141, MCP4142, MCP4161, MCP4162
Dual Resistor Network: MCP4241, MCP4242, MCP4261, MCP4262

7-bit, 128 Resistors (129 steps): MCP4141, MCP4142, MCP4241, MCP4142
8-bit, 256 Resistors (257 steps): MCP4161, MCP4162, MCP4261, MCP4162

Digital Potentiometer - Microchip

Specifikationer
Attribute Value
Control Interface Serial-SPI
Resistance Value 10kΩ
Number of Positions 257
Taper Type Linear
Memory Type Non-Volatile
Number of Pots per Package 1
Mounting Type Through Hole
Package Type PDIP
Pin Count 8
Power Supply Type Single
Typical Single Supply Voltage 1.8 to 5.5 V
Dimensions 0.4 x 0.28 x 0.195in
Height 4.95mm
Minimum Operating Temperature -40 °C
Width 0.28in
Maximum Operating Temperature +125 °C
Length 10.16mm
66 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each (In a Pack of 2)
8,945 kr
(exkl. moms)
11,181 kr
(inkl. moms)
Enheter
Per unit
Per Pack*
2 - 8
8,945 kr
17,89 kr
10 - 22
8,58 kr
17,16 kr
24 - 98
8,17 kr
16,34 kr
100 +
7,65 kr
15,30 kr
Förpackningsalternativ:
Related Products
NCP1422 is a monolithic micropower high frequency step-up ...
Description:
NCP1422 is a monolithic micropower high frequency step-up switching converter IC specifically designed for battery-operated hand-held electronic products up to 800mA loading. It integrates Sync-Rect to improve efficiency and to eliminate the external Schottky Diode. High switching frequency (up to ...
The AUIR3315(S) is a fully protected 4 terminals ...
Description:
The AUIR3315(S) is a fully protected 4 terminals high side switch. The input signal is referenced to Vcc. When the input voltage Vcc - Vin is higher than the specified threshold, the output power Mosfet is turned on. When the ...
256-positionEnd-to-end resistance: 5 kΩ, 10 kΩ, 50 kΩ, ...
Description:
256-positionEnd-to-end resistance: 5 kΩ, 10 kΩ, 50 kΩ, 100 kΩCompact SOT-23-8 (2.9 mm ´ 3 mm) packageSPI-compatible interfacePower-on preset to midscaleSingle supply: 2.7 V to 5.5 VLow temperature coefficient: 45 ppm/°CLow power, IDD = 8 μAWide operating temperature: –40°C to ...
256-position digital potentiometerTwo-time programmable (TTP) set-and-forget resistance setting ...
Description:
256-position digital potentiometerTwo-time programmable (TTP) set-and-forget resistance setting allows second-chance permanent programmingUnlimited adjustments prior to one-time programming (OTP) activationOTP overwrite allows dynamic adjustments with user-defined preset2.5 kΩ, 10 kΩ, 50 kΩ, 100 kΩend-to-end ...