FTPD-1, Chip Programming Adapter

  • RS-artikelnummer 917-0726
  • Tillv. art.nr FTPD-1
  • Tillverkare / varumärke Bridgetek
Datablad
Lagstiftning och ursprungsland
RoHS-Försäkran
Produktdetaljer

FTPD-1 Programmer/Debugger Module, FTDI Chip

The FTDI Chip FTPD-1 is a programming/debugging module which you can use to program several FTDI MCU devices but predominantly the FT51A (RS 917-0704). It has an FT230X USB to UART converter (RS 888-8710) and a dual buffer to generate a single-line half-duplex UART signal with no handshake.

This module provides a switched 5 V power supply to the target device and configured so it does not infringe USB compliance regulations for bus power.

Supplied with a berg connector ribbon cable, however you can also use pogo pin cables.

Full-Speed USB to UART converter
Single half-duplex UART data pin input/output
Two dedicated GPIOs to control Reset# and Prog# outputs
TXDEN line to control the direction of the half-duplex UART data
PWREN# line to control the power supply
2 x 3 way 2.54 mm pitch shrouded male header
150 mm ribbon cable with Female to Female 2.54 mm pitch 2 x 3 way connectors
Protected by resettable fuse with 0.5 A hold current and Schottky diode on the output power line.
Power output indication LED

Denna produkt har utgått
Related Products
Texas Instruments MSP-TS430DA38 is a standalone ZIF socket ...
Description:
Texas Instruments MSP-TS430DA38 is a standalone ZIF socket target board used to program and debug the MSP430 in-system through the JTAG interface or the Spy Bi-Wire (2-wire JTAG) protocol. The development board supports some MSP430 Flash parts in a 38-pin ...
Texas Instruments MSP-TS430PW24 is a standalone ZIF socket ...
Description:
Texas Instruments MSP-TS430PW24 is a standalone ZIF socket target board used to program and debug the MSP430 in-system through the JTAG interface or the Spy Bi-Wire (2-wire JTAG) protocol. The development board supports all MSP430AFE2xx Flash parts in a 24-pin ...
The Microchip Technology Chip programming adapter is a ...
Description:
The Microchip Technology Chip programming adapter is a connectivity board. It supports JTAG, SWD and ICSP protocols in multiple connector formats. It is useful for debugging legacy AVR Xplained demonstration boards with MPLAB PICkit 4 debuggers. • 1 x 8 ...
In-Circuit Debugger (ICD 2) allows the debugging of ...
Description:
In-Circuit Debugger (ICD 2) allows the debugging of a range of PIC microcontrollers through the MPLAB® Integrated Development Environment (IDE). The ICD 2 module connects between the PC and the user's target board allowing direct in-circuit debugging of the target ...