Ring Seal TSN516C, 70mm ID

  • RS-artikelnummer 506-713
  • Tillv. art.nr TSN516C
  • Tillverkare / varumärke SKF
Datablad
Lagstiftning och ursprungsland
Ej tillämpbart
COO (Country of Origin): SE
Produktdetaljer

Felt Ring Seals Type C

Felt ring seals are simple but efficient seals for use with grease lubrication. They can be operated at peripheral speeds of up to 4 m/s (800 ft/min). The seals can be used at higher speeds, but a small gap forms between the felt and the shaft. As a result the seals become non-rubbing gap-type seals.
For pillow block housings with bearings on adapter sleeves and shafts not exceeding a surface roughness of Ra 3.2 μm, the felt ring seals are split. Oil-impregnated felt is inserted into Light Alloy half-rings and the seals inserted into the grooves of the housing. The rubber O-section cords should be put into the grooves first as they prevent the seals from turning.
SNL pillow block housings for bearings mounted on the cylindrical seatings of stepped shafts, sizes 205 to 218 inclusive, can also be supplied with felt seals. In this case, the seals consist of loose felt strips that can be inserted into the sealing grooves. Before mounting the FS felt strips, soak for a few minutes in hot oil. The permissible angular misalignment for felt seals is approximately 0.5°. The seal counterface on the shaft should be ground and the surface roughness should not exceed Ra 3.2 μm (125 RMS). The axial movement on the shaft relative to the housing is not limited when felt seals are used. The ready-to-mount felt ring seals (in Light Alloy half-rings) are always supplied in packs of two. The felt ring seals are identified by the designation prefix TSN followed by the size identification and the suffix C, for example, TSN 511 C.

Plummer Blocks, Bearing Lubrication and Accessories

Specifikationer
Attribute Value
Inside Diameter 70mm
Material Felt
Centre Height 95mm
Mount Hole Size 20 mm
Length 315mm
Depth 120mm
Overall Height 177mm
Mount Hole Centre-to-Centre 260mm
For Use With Type C for Plummer Block Housed Units
1 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
179,92 kr
(exkl. moms)
224,90 kr
(inkl. moms)
Enheter
Per unit
1 - 4
179,92 kr
5 - 9
172,68 kr
10 - 24
169,16 kr
25 +
165,54 kr
Related Products
These bearings are designed to accommodate shaft deflection ...
Description:
These bearings are designed to accommodate shaft deflection when running and will also cope with initial misalignment. The double row bearing is designed primarily to withstand radial load with a small capacity for axial load. Also available with ring seals ...
The BSN series of ball screw support bearings ...
Description:
The BSN series of ball screw support bearings are double row, angular contact thrust ball bearings, with a 60° contact angle. They are equivalent to two single row bearings in a back-to-back arrangement, with a single outer ring. Bearings are ...
Also known as oil seals, these seals are ...
Description:
Also known as oil seals, these seals are ideal for excluding dirt, dust, water or any other contaminant whilst retaining lubricant in rotary shaft equipment. They are generally used as a means of protecting the bearings of rotating shafts. Replaceable ...
The miniature type cam followers from IKO are ...
Description:
The miniature type cam followers from IKO are some of the smallest cam followers in the world. Designed to be compact, they have a stud diameter ranging from 1.4 mm to 6 mm and an outside diameter from 4 mm ...