Ultimaker Nozzle for use with Olsson Block 0.5mm

  • RS-artikelnummer 110-1986
  • Tillv. art.nr OBS001
  • Tillverkare / varumärke Ultimaker
Datablad
Lagstiftning och ursprungsland
Ej tillämpbart
COO (Country of Origin): NL
Produktdetaljer

Ultimaker 2 Jet Nozzle - Stainless Steel

The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With this special stainless steel nozzle, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean it efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer

If you print with abbrasive material like Carbon filled filament or Glowfill, this is the nozzle to have! Stainless steel is much stronger, it will wear down much slower than classic brass nozzles which can wear out during one long print! Only thing to remember is to print a little slower because of the difference in conductivity between stainless steel and brass

Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Ultimaker Accessories

Specifikationer
Attribute Value
Product Type Nozzle
For Use With Olsson Block
Nozzle Material Stainless Steel
Nozzle Size 0.5mm
11 I lager för leverans inom 1 arbetsdagar
Pris (ex. moms) Each
482,76 kr
(exkl. moms)
603,45 kr
(inkl. moms)
Enheter
Per unit
1 +
482,76 kr
Related Products
Heating block for precise filament extruding complete with ...
Description:
Heating block for precise filament extruding complete with nozzle. It is recommended for use with all materials from Z-Filament Series. Replace Hot-End V1 with this new version and achieve better printing results. • Replacement part compatible with the Zortrax M200 ...
Ensure continuous printing with a handy set of ...
Description:
Ensure continuous printing with a handy set of five 0.25 mm nozzles for the Ultimaker 2+ series. Quick and easy to change, they help you achieve a greater level of detail.
Print without interruption with a handy set of ...
Description:
Print without interruption with a handy set of five 0.6 mm nozzles for the Ultimaker 2+ series. Simple to replace, they help you achieve a good level of detail at a higher speed.
Ensure a seamless printing experience with a handy ...
Description:
Ensure a seamless printing experience with a handy set of five 0.8 mm nozzles for the Ultimaker 2+ series. These Ultimaker replacement nozzles are easy to replace and enable you to prototype faster. The Ultimaker 2+ is a user-friendly solution ...